DDP - Setup p1

Ramp Setup
ramp supplies

Make ramp by cutting 5/8"-1" inner diameter foam pipe insulation completely in half. This should yield two ramps per 6' length of insulation.

cup as base

Make sure the marble you use fits in the ramp, i.e. less than the inner diameter of the pipe.

Use a standard styrofoam coffee cup, turned upside down, for the launch-end base of the ramp. Cut a corner off the cup equal to the thickness of the foam pipe.

Tape one end of the foam pipe to the clipped corner of the cup.

long view measuring paper

You also need to tape down 3 or 4 sheets of paper on the floor in front of your ramp, so you can measure where the marble lands later.

Back Main Menu Setup p2




Developed by Dr. Garrett R. Love for
Graphic of Shodor Logo The Shodor Education Foundation, Inc.
Copyright © 2001-2004. Last modified:
Questions or comments about this page should be directed to rbroadnax@shodor.org