Page 3
Load the ProMotion or ProMotion applet, and enter data off your Data Table into the applet.
The 'Launch X' field should be left as 0. Enter your finding
for Y1
into the 'Launch Y' field. In the 'Land X' and
'Land Y' fields, enter X1
&
Y2
values respectively. Then fill in your
ΔY, ΔX
values into the 'Launch dX' and 'Launch dY'
fields.
Make sure that 'Type' is set to 'Point-Point-Slope' (the
default) and that units are in cm, then click 'New Graph'. You may need to zoom
in or out X or Y a bit to see the full curve computed, but the important thing
to see is the calculated velocity, labeled 'Initial Velocity' in the lower-left
portion of the applet. Write this number down on your Data Table, next to the X1
entry that you used in ProMotion
or
JavaScript ProMotion.
Repeat these steps for each of the X1
entries you
have recorded.